The 7-Minute Rule for Time Clock Rounding

By the USA Calculators Team · checked against official sources

What the 7-minute rule is

Many time clocks record the exact minute you punch in and out, but the payroll system rounds each punch to the nearest quarter hour (15 minutes). Because 7.5 minutes is the halfway point, the result is the “7-minute rule”:

  • 1 to 7 minutes past a quarter hour: the punch rounds down.
  • 8 to 14 minutes past a quarter hour: the punch rounds up.
Actual punch Rounded to 15 min Rounded to 6 min (tenths) Rounded to 5 min
7:52 AM 7:45 AM 7:54 AM 7:50 AM
7:53 AM 8:00 AM 7:54 AM 7:55 AM
8:07 AM 8:00 AM 8:06 AM 8:05 AM
8:08 AM 8:15 AM 8:06 AM 8:10 AM
4:52 PM 4:45 PM 4:54 PM 4:50 PM
4:53 PM 5:00 PM 4:54 PM 4:55 PM
5:07 PM 5:00 PM 5:06 PM 5:05 PM

So any punch from 7:53 to 8:07 counts as 8:00. The table was produced with the same rounding function our time card calculator uses, which offers 5, 6, 10 and 15-minute rounding.

What federal law says

There is no federal statute called the 7-minute rule. It comes from a Department of Labor regulation, 29 CFR 785.48(b), which says employers may round starting and stopping times to the nearest 5 minutes, tenth of an hour, or quarter of an hour. The regulation accepts this practice on one condition: it must average out so that employees are fully paid for the time they actually work over a period of time. If a rounding practice, as applied, results in employees being undercompensated, it violates the FLSA.

Three points follow from that wording:

  1. Rounding must be neutral. It has to go both ways. A system that rounds only down, or rounds in-punches up and out-punches down, is not neutral even if each punch follows a rounding table.
  2. Neutral on paper is not enough. Courts look at how the policy works in practice. If employees routinely arrive a few minutes early and leave a few minutes late, a nominally neutral rule can still take time from them every day.
  3. Employers must keep records. The FLSA requires accurate records of hours worked. Rounding is a payroll convention applied to those records, not a reason to stop recording them.

A related regulation, 29 CFR 785.47, lets employers ignore truly insignificant amounts of time that cannot practically be recorded (the “de minimis” rule). It does not cover regular, predictable work such as booting up a computer every morning, and an employer cannot use it to ignore a set amount of time that is part of your daily routine.

Early and late punches

Rounding is different from the question of whether time is work at all. Under 785.48(a), if you clock in early but are not working (you are chatting, getting coffee or waiting for the shift to start), the employer does not have to count that time. The same applies to punching out a few minutes late after work has stopped.

That changes once you do anything for the employer. If you clock in at 7:50 and start answering customer calls, the time from 7:50 is hours worked, regardless of rounding. An employer that expects you to be at your station and logged in when the shift begins should count the time it takes to get there.

How much rounding can cost

Here are two days at $20 an hour with quarter-hour rounding.

Day A: in 7:54 AM, out 5:05 PM, 60-minute unpaid lunch. Actual time: 8 hours 11 minutes (491 minutes). Rounded: 8:00 AM to 5:00 PM, so 8 hours (480 minutes). You lose 11 minutes.

Day B: in 8:06 AM, out 4:38 PM, 30-minute lunch. Actual: 8 hours 2 minutes (482 minutes). Rounded: 8:00 AM to 4:45 PM, so 8 hours 15 minutes (495 minutes). You gain 13 minutes.

Over time, days like A and B should roughly cancel. The problem is a pattern. If your habit, or your employer’s rules, make Day A your normal day, you lose 55 minutes a week. At $20 an hour that is about $18.33 a week, or about $917 over 50 weeks. If those minutes would have been overtime hours, the loss is 1.5 times larger.

To check your own pattern, write down your actual punches for two or three weeks, enter them in the time card calculator once with no rounding and once with your employer’s rounding, and compare the totals. Convert any leftover minutes with the minutes to decimal converter.

Rounding and overtime

Rounding applies before overtime is figured. If rounding adds 15 minutes to a week of exactly 40 hours, that quarter hour is overtime at 1.5 times your regular rate. If rounding trims a week of 40 hours 10 minutes to exactly 40, the overtime disappears. That is why rounding disputes often show up in overtime claims. Our guide to FLSA overtime rules explains how the 40-hour test and the regular rate work.

States with stricter rules

Most states follow the federal rounding regulation or have no rule of their own. California is the main exception, and the trend there is against rounding:

  • In Troester v. Starbucks (2018), the California Supreme Court held that the federal de minimis rule does not apply to California wage claims for regularly occurring off-the-clock work.
  • In Donohue v. AMN Services (2021), the same court held that employers may not round meal-period punches, because California’s meal-break rules are measured to the minute, and that time records showing short or late meal breaks create a presumption of a violation.
  • California appellate courts have also ruled against rounding policies that were neutral in form but shorted employees in practice, and the California Supreme Court agreed to review the issue in Camp v. Home Depot. If you work in California, check the current state of that case before relying on any rounding policy.

Because the legal risk is high, many California employers now pay to the exact minute. Elsewhere, a few states regulate specific industries or require exact recordkeeping, so state labor department guidance is worth checking if you see a consistent gap. Your state page under labor laws by state lists the agency that handles wage claims.

Practical tips

  • Keep your own log. A note of your actual punch times is the evidence you need if the totals do not add up.
  • Read the policy. Ask payroll whether punches are rounded and to what increment. Employers are not required to tell you in advance, but most will answer.
  • Watch for one-way rules. A rule that bars clocking in before 7:53 but lets punches up to 8:07 round to 8:00 favors the employer every time.
  • Do not work off the clock. Pre-shift setup, logging in and post-shift cleanup are work time. Punch in before you start.
  • Tenths are more precise. Six-minute rounding never moves a punch by more than 3 minutes, and it lines up with decimal hours (0.1 hour = 6 minutes), which is why many payroll systems use it.

If you think rounding is costing you money, you can contact the DOL Wage and Hour Division or your state labor department. Federal wage claims generally go back two years, or three for willful violations.

Questions

What is the 7-minute rule?

It is the common name for rounding time punches to the nearest quarter hour. A punch 1 to 7 minutes past a quarter hour rounds down, and a punch 8 to 14 minutes past rounds up, so 8:07 becomes 8:00 and 8:08 becomes 8:15.

Is the 7-minute rule legal?

Federal regulations (29 CFR 785.48(b)) allow rounding to the nearest 5 minutes, tenth of an hour or quarter hour, as long as it averages out over time so employees are paid for all the time they actually work. A system that mostly rounds in the employer's favor violates the FLSA.

If I clock in at 7:53, when does my time start?

With quarter-hour rounding, 7:53 rounds up to 8:00. A 7:52 punch rounds down to 7:45. If you are not working before your shift starts, the employer may also disregard an early punch.

Can my employer round my time down every time?

No. Rounding must be neutral. Rounding only down, rounding in-punches up and out-punches down, or combining rounding with a rule that stops you from clocking in early in a way that cuts your paid time is not permitted.

Is time rounding allowed in California?

California courts are much stricter. Rounding of meal-period punches is not allowed (Donohue v. AMN Services, 2021), and appellate courts have rejected rounding policies that shorted employees in practice. Many California employers now pay to the exact minute.

How much can rounding cost me?

If rounding trims 11 minutes a day, that is 55 minutes a week. At $20 an hour it is about $18.33 a week, or roughly $917 over 50 weeks.

What is the difference between the 7-minute rule and rounding to tenths?

Quarter-hour rounding moves a punch by up to 7 minutes. Rounding to the tenth of an hour (6 minutes) moves it by up to 3 minutes, so it is more precise, and it matches decimal hours: 0.1 hour equals 6 minutes.

Sources

  1. eCFR — 29 CFR 785.48, Use of time clocks
  2. eCFR — 29 CFR 785.47, Insubstantial or insignificant periods of time
  3. U.S. DOL — Fact Sheet #22: Hours Worked Under the FLSA
  4. U.S. DOL — Recordkeeping requirements under the FLSA (Fact Sheet #21)

Checked against the 2026 rules. How we calculate